Defence And Security Equipment Machine Housings in food grade polypropylene: Thick Gauge Forming and Specification

Vacuum formed machine housings are used across defence and security equipment because they can be produced without the tooling spend of injection moulding and without the weight of sheet metal. This page covers how 3 mm food grade polypropylene sheet is formed for defence and security equipment, what tolerances are realistic, and what has to be on the drawing before tooling starts.

The route below is the one used for most of the machine housings shipped from this plant: sheet is heated on the forming machine, drawn over an aluminium or composite mould, cooled on a jig, then trimmed on a 5-axis router. For machine housings the sheet gauge is selected from the load case rather than from habit, and food grade polypropylene is the material most often specified for this combination.

Typical specification

Where these parts are used

• console covers for defence and security equipment
• antenna covers for defence and security equipment
• transport trays for defence and security equipment
• case shells for defence and security equipment
• machine housings in general defence and security equipment builds

How the part is made

1. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
2. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
3. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
4. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
5. The part cools on a jig so the shape is held while the material stabilises.
6. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
7. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.

Material notes: food grade polypropylene

Food grade polypropylene is used for trays, hoppers and liners that touch product, and it can be washed with caustic cleaners.

Design tips for this part

• avoid sharp steps in the mould, which show as chill marks on the finished surface
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• plan the trim line on a flat face so the router can hold tolerance
• use corner radii of at least three times the sheet thickness to avoid thinning
• call out the finish on the drawing: mould texture, paint, or as-formed gloss

Quality and inspection

Batch releases carry a dimensional report, material certificate and, where agreed, PPAP or ISIR documentation. Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch.

Cost and lead time

Tooling is the main cost driver at low volume, so a 3 mm machine housings for defence and security equipment is usually quoted with a composite or printed mould first and the aluminium tool cut once the design is frozen. That keeps the first article cost low and gives a real part to test before the production tool exists. The result is lower piece price compared with the alternatives, and a piece price that stays stable across repeat releases.

• Sample tooling: 7–15 working days
• Production tooling: 3–4 weeks
• Repeat orders run on stored tooling with no new proving run

Frequently asked questions

How long does tooling take?

Sample and first article tooling is usually cut in 7 to 15 working days. Production aluminium tools take 3 to 4 weeks depending on size and cooling layout.

What do you need to quote?

A 3D file or drawing, the material if it is fixed, the annual quantity and the finish. Photos of the current part are enough for a first estimate.

Do you supply certificates?

Material certificates, dimensional reports and flame retardancy or food contact declarations are issued with the shipment where the specification requires them.

Getting started

Send the drawing or a photo of the current machine housings with the quantity and the finish. The first reply is a manufacturability review with the wall thickness, material and a quotation, so the decision is made on facts rather than on a price alone.