Custom Fenders Thermoforming in HIPS for Signage And Wayfinding at 10 mm

Vacuum formed fenders are used across signage and wayfinding because they can be produced without the tooling spend of injection moulding and without the weight of sheet metal. This page covers how 10 mm HIPS sheet is formed for signage and wayfinding, what tolerances are realistic, and what has to be on the drawing before tooling starts.

The route below is the one used for most of the fenders shipped from this plant: sheet is heated on the forming machine, drawn over an aluminium or composite mould, cooled on a jig, then trimmed on a 5-axis router. For fenders the sheet gauge is selected from the load case rather than from habit, and HIPS is the material most often specified for this combination.

Typical specification

Where these parts are used

• direction panel shells for signage and wayfinding
• sign faces for signage and wayfinding
• light box covers for signage and wayfinding
• post caps for signage and wayfinding
• fenders in general signage and wayfinding builds

How the part is made

1. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
2. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
3. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
4. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
5. The part cools on a jig so the shape is held while the material stabilises.
6. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
7. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.

Material notes: HIPS

HIPS is the low cost route for indoor liners and disposable trays where impact strength is not critical.

Design tips for this part

• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• plan the trim line on a flat face so the router can hold tolerance
• avoid sharp steps in the mould, which show as chill marks on the finished surface
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• use corner radii of at least three times the sheet thickness to avoid thinning

Quality and inspection

First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample. Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report.

Cost and lead time

Tooling is the main cost driver at low volume, so a 10 mm fenders for signage and wayfinding is usually quoted with a composite or printed mould first and the aluminium tool cut once the design is frozen. That keeps the first article cost low and gives a real part to test before the production tool exists. The result is shorter lead time compared with the alternatives, and a piece price that stays stable across repeat releases.

• Sample tooling: 7–15 working days
• Production tooling: 3–4 weeks
• Repeat orders run on stored tooling with no new proving run

Frequently asked questions

Can you match an existing part?

Yes. Send a sample or scan and the part can be reverse engineered, with the wall thickness and material measured from the sample.

How long does tooling take?

Sample and first article tooling is usually cut in 7 to 15 working days. Production aluminium tools take 3 to 4 weeks depending on size and cooling layout.

What do you need to quote?

A 3D file or drawing, the material if it is fixed, the annual quantity and the finish. Photos of the current part are enough for a first estimate.

Getting started

Send the drawing or a photo of the current fenders with the quantity and the finish. The first reply is a manufacturability review with the wall thickness, material and a quotation, so the decision is made on facts rather than on a price alone.