3 mm ABS Storage Bins Vacuum Forming for Cleaning And Sanitation Equipment

Vacuum formed storage bins are used across cleaning and sanitation equipment because they can be produced without the tooling spend of injection moulding and without the weight of sheet metal. This page covers how 3 mm ABS sheet is formed for cleaning and sanitation equipment, what tolerances are realistic, and what has to be on the drawing before tooling starts.

The route below is the one used for most of the storage bins shipped from this plant: sheet is heated on the forming machine, drawn over an aluminium or composite mould, cooled on a jig, then trimmed on a 5-axis router. For storage bins the sheet gauge is selected from the load case rather than from habit, and ABS is the material most often specified for this combination.

Typical specification

Where these parts are used

• scrubber tanks for cleaning and sanitation equipment
• solution tank liners for cleaning and sanitation equipment
• machine covers for cleaning and sanitation equipment
• tool trays for cleaning and sanitation equipment
• storage bins in general cleaning and sanitation equipment builds

How the part is made

1. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
2. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
3. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
4. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
5. The part cools on a jig so the shape is held while the material stabilises.
6. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
7. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.

Material notes: ABS

ABS is the default choice where the part needs stiffness, a paint finish and clean trimmed edges. It forms evenly, takes texture well and bonds with standard solvents.

Design tips for this part

• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• use corner radii of at least three times the sheet thickness to avoid thinning
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• plan the trim line on a flat face so the router can hold tolerance

Quality and inspection

First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample. Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch.

Cost and lead time

Tooling is the main cost driver at low volume, so a 3 mm storage bins for cleaning and sanitation equipment is usually quoted with a composite or printed mould first and the aluminium tool cut once the design is frozen. That keeps the first article cost low and gives a real part to test before the production tool exists. The result is lighter weight compared with the alternatives, and a piece price that stays stable across repeat releases.

• Sample tooling: 7–15 working days
• Production tooling: 3–4 weeks
• Repeat orders run on stored tooling with no new proving run

Frequently asked questions

How long does tooling take?

Sample and first article tooling is usually cut in 7 to 15 working days. Production aluminium tools take 3 to 4 weeks depending on size and cooling layout.

Do you supply certificates?

Material certificates, dimensional reports and flame retardancy or food contact declarations are issued with the shipment where the specification requires them.

What quantities make sense?

Vacuum forming pays off from roughly 25 pieces up to several thousand a year. Below that, printed or composite tooling keeps the setup cost low.

Getting started

Send the drawing or a photo of the current storage bins with the quantity and the finish. The first reply is a manufacturability review with the wall thickness, material and a quotation, so the decision is made on facts rather than on a price alone.