Dashboards 5 mm polypropylene Supplier for Cleaning And Sanitation Equipment Equipment

These polypropylene dashboards are thick gauge vacuum formed parts supplied to drawing for cleaning and sanitation equipment. They are formed from polypropylene sheet at 5 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• polypropylene keeps the weight down while stiffness is held through the formed shape
• Two coat polyurethane paint finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• ISO 9001 quality system

Typical applications

• solution tank liners
• tool trays
• scrubber tanks
• machine covers
• dashboards used across general cleaning and sanitation equipment builds

How it is made

1. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
2. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
3. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
4. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
5. The part cools on a jig so the shape is held while the material stabilises.

Material: polypropylene

Polypropylene survives repeated impact and most cleaning chemicals. Its low forming temperature keeps cycles short, but it shrinks more, so the mould is cut with the shrink factor built in.

Design notes

• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• plan the trim line on a flat face so the router can hold tolerance
• hold the draw ratio near 1:1 for deep parts, or specify plug assist

Finishing and assembly options

• two coat polyurethane paint
• clear protective film
• as formed gloss
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch. Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report.

• PPAP or ISIR on request
• dimension reports with every release
• material certificates with every batch

Packing and delivery

Parts are nested to save freight, with returnable dunnage available on repeat routes. Standard lead time to first article is 7–15 working days, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Request a quotation

Send the drawing or a photo of the current dashboards with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.