ABS/PC Dashboards Vacuum Formed in 12 mm for Battery Energy Storage

These ABS/PC dashboards are thick gauge vacuum formed parts supplied to drawing for battery energy storage. They are formed from ABS/PC sheet at 12 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• ABS/PC keeps the weight down while stiffness is held through the formed shape
• Two coat polyurethane paint finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• RoHS compliant grades available

Typical applications

• vent shrouds
• cabinet liners
• cell trays
• battery pack covers
• dashboards used across general battery energy storage builds

How it is made

1. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
2. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
3. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
4. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
5. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.

Material: ABS/PC

ABS/PC carries higher heat resistance than ABS alone, which matters for housings around motors, drives and power electronics.

Design notes

• plan the trim line on a flat face so the router can hold tolerance
• avoid sharp steps in the mould, which show as chill marks on the finished surface
• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly

Finishing and assembly options

• two coat polyurethane paint
• EMI shielding coating
• matte finish
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch. Batch releases carry a dimensional report, material certificate and, where agreed, PPAP or ISIR documentation.

• food contact declarations available
• REACH compliant sheet available
• material certificates with every batch

Packing and delivery

Each part is bagged, edges protected with foam, then cartonised for container loading. Standard lead time to first article is 2–3 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Request a quotation

Send the drawing or a photo of the current dashboards with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.