recycled HDPE Plastic Enclosures Vacuum Formed in 2 mm for Industrial Robotics

These recycled HDPE plastic enclosures are thick gauge vacuum formed parts supplied to drawing for industrial robotics. They are formed from recycled HDPE sheet at 2 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• recycled HDPE keeps the weight down while stiffness is held through the formed shape
• Anti graffiti coating finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• PPAP or ISIR on request

Typical applications

• controller housings
• cable trays
• teach pendant cases
• robot base covers
• plastic enclosures used across general industrial robotics builds

How it is made

1. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
2. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
3. The part cools on a jig so the shape is held while the material stabilises.
4. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
5. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.

Material: recycled HDPE

Recycled HDPE sheet lowers material cost and supports sustainability targets, with mechanical properties close to virgin sheet for non critical parts.

Design notes

• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• avoid sharp steps in the mould, which show as chill marks on the finished surface
• use corner radii of at least three times the sheet thickness to avoid thinning

Finishing and assembly options

• anti graffiti coating
• as formed gloss
• silk screened markings
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch. Batch releases carry a dimensional report, material certificate and, where agreed, PPAP or ISIR documentation.

• ISO 9001 quality system
• PPAP or ISIR on request
• dimension reports with every release

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 3–4 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Request a quotation

Send the drawing or a photo of the current plastic enclosures with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.