ESD safe ABS Protective Guards Vacuum Formed in 5 mm for Defence And Security Equipment

These ESD safe ABS protective guards are thick gauge vacuum formed parts supplied to drawing for defence and security equipment. They are formed from ESD safe ABS sheet at 5 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• ESD safe ABS keeps the weight down while stiffness is held through the formed shape
• Clear protective film finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• food contact declarations available

Typical applications

• console covers
• transport trays
• antenna covers
• case shells
• protective guards used across general defence and security equipment builds

How it is made

1. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
2. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
3. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
4. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
5. The part cools on a jig so the shape is held while the material stabilises.

Material: ESD safe ABS

ESD safe ABS keeps surface resistivity in the dissipative range, used for electronics carriers, tray systems and equipment covers in assembly areas.

Design notes

• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• use corner radii of at least three times the sheet thickness to avoid thinning
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• hold the draw ratio near 1:1 for deep parts, or specify plug assist

Finishing and assembly options

• clear protective film
• silk screened markings
• hot stamped accents
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch.

• dimension reports with every release
• UL94 V-0 grades available
• material certificates with every batch

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 2–3 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Request a quotation

Send the drawing or a photo of the current protective guards with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.