ABS/PC Cable Covers Vacuum Formed in 12 mm for Playground Equipment

These ABS/PC cable covers are thick gauge vacuum formed parts supplied to drawing for playground equipment. They are formed from ABS/PC sheet at 12 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• ABS/PC keeps the weight down while stiffness is held through the formed shape
• Mould texture finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• UL94 V-0 grades available

Typical applications

• climbing tower caps
• panel covers
• seat buckets
• slide shells
• cable covers used across general playground equipment builds

How it is made

1. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
2. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
3. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
4. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
5. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.

Material: ABS/PC

ABS/PC carries higher heat resistance than ABS alone, which matters for housings around motors, drives and power electronics.

Design notes

• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• use corner radii of at least three times the sheet thickness to avoid thinning
• avoid sharp steps in the mould, which show as chill marks on the finished surface

Finishing and assembly options

• mould texture
• pad printed logos
• hot stamped accents
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch. First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample.

• dimension reports with every release
• UL94 V-0 grades available
• REACH compliant sheet available

Packing and delivery

Parts are nested to save freight, with returnable dunnage available on repeat routes. Standard lead time to first article is 3–4 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Request a quotation

Send the drawing or a photo of the current cable covers with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.