Thick Gauge LDPE Wheel Covers in 8 mm – Playground Equipment Range

These LDPE wheel covers are thick gauge vacuum formed parts supplied to drawing for playground equipment. They are formed from LDPE sheet at 8 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• LDPE keeps the weight down while stiffness is held through the formed shape
• Two coat polyurethane paint finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• ISO 9001 quality system

Typical applications

• seat buckets
• slide shells
• climbing tower caps
• panel covers
• wheel covers used across general playground equipment builds

How it is made

1. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
2. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
3. The part cools on a jig so the shape is held while the material stabilises.
4. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
5. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.

Material: LDPE

LDPE is flexible and tough in thin section, used for liners and protective covers that have to bend during fitting.

Design notes

• use corner radii of at least three times the sheet thickness to avoid thinning
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• hold the draw ratio near 1:1 for deep parts, or specify plug assist

Finishing and assembly options

• two coat polyurethane paint
• clear protective film
• powder coat finish
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Batch releases carry a dimensional report, material certificate and, where agreed, PPAP or ISIR documentation. Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report.

• ISO 9001 quality system
• UL94 V-0 grades available
• food contact declarations available

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 10–15 working days, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Request a quotation

Send the drawing or a photo of the current wheel covers with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.