4 mm recycled HDPE Hoods Manufacturer for Elevator And Escalator Interiors

These recycled HDPE hoods are thick gauge vacuum formed parts supplied to drawing for elevator and escalator interiors. They are formed from recycled HDPE sheet at 4 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• recycled HDPE keeps the weight down while stiffness is held through the formed shape
• Satin finish finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• REACH compliant sheet available

Typical applications

• ceiling panels
• landing sill covers
• car linings
• handrail deck covers
• hoods used across general elevator and escalator interiors builds

How it is made

1. The part cools on a jig so the shape is held while the material stabilises.
2. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
3. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
4. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
5. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.

Material: recycled HDPE

Recycled HDPE sheet lowers material cost and supports sustainability targets, with mechanical properties close to virgin sheet for non critical parts.

Design notes

• avoid sharp steps in the mould, which show as chill marks on the finished surface
• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• use corner radii of at least three times the sheet thickness to avoid thinning

Finishing and assembly options

• satin finish
• mould texture
• two coat polyurethane paint
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. Batch releases carry a dimensional report, material certificate and, where agreed, PPAP or ISIR documentation.

• REACH compliant sheet available
• material certificates with every batch
• ISO 9001 quality system

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 3–4 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Request a quotation

Send the drawing or a photo of the current hoods with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.