Hoods HDPE in 4 mm for Elevator And Escalator Interiors – Formed to Drawing

These HDPE hoods are thick gauge vacuum formed parts supplied to drawing for elevator and escalator interiors. They are formed from HDPE sheet at 4 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• HDPE keeps the weight down while stiffness is held through the formed shape
• Hot stamped accents finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• food contact declarations available

Typical applications

• landing sill covers
• ceiling panels
• handrail deck covers
• car linings
• hoods used across general elevator and escalator interiors builds

How it is made

1. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
2. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
3. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
4. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
5. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.

Material: HDPE

HDPE is chosen for chemical resistance and impact strength at low temperature. It needs more heat and a longer cooling cycle than ABS, and it is painted only after flame or plasma treatment.

Design notes

• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• plan the trim line on a flat face so the router can hold tolerance
• avoid sharp steps in the mould, which show as chill marks on the finished surface
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly

Finishing and assembly options

• hot stamped accents
• EMI shielding coating
• silk screened markings
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Batch releases carry a dimensional report, material certificate and, where agreed, PPAP or ISIR documentation. Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report.

• RoHS compliant grades available
• UL94 V-0 grades available
• dimension reports with every release

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 3–4 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Request a quotation

Send the drawing or a photo of the current hoods with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.