Thick Gauge ABS/PC Display Shells in 3 mm – Solar And Wind Energy Range

These ABS/PC display shells are thick gauge vacuum formed parts supplied to drawing for solar and wind energy. They are formed from ABS/PC sheet at 3 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• ABS/PC keeps the weight down while stiffness is held through the formed shape
• Pad printed logos finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• material certificates with every batch

Typical applications

• combiner box housings
• nacelle access panels
• cable covers
• inverter covers
• display shells used across general solar and wind energy builds

How it is made

1. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
2. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
3. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
4. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
5. The part cools on a jig so the shape is held while the material stabilises.

Material: ABS/PC

ABS/PC carries higher heat resistance than ABS alone, which matters for housings around motors, drives and power electronics.

Design notes

• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• use corner radii of at least three times the sheet thickness to avoid thinning
• plan the trim line on a flat face so the router can hold tolerance

Finishing and assembly options

• pad printed logos
• clear protective film
• two coat polyurethane paint
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample.

• PPAP or ISIR on request
• ISO 9001 quality system
• material certificates with every batch

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 7–15 working days, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Request a quotation

Send the drawing or a photo of the current display shells with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.