12 mm recycled HDPE Equipment Covers Manufacturer for Medical Equipment

These recycled HDPE equipment covers are thick gauge vacuum formed parts supplied to drawing for medical equipment. They are formed from recycled HDPE sheet at 12 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• recycled HDPE keeps the weight down while stiffness is held through the formed shape
• Satin finish finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• REACH compliant sheet available

Typical applications

• imaging equipment panels
• device trolleys
• monitor shrouds
• dialysis machine covers
• equipment covers used across general medical equipment builds

How it is made

1. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
2. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
3. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
4. The part cools on a jig so the shape is held while the material stabilises.
5. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.

Material: recycled HDPE

Recycled HDPE sheet lowers material cost and supports sustainability targets, with mechanical properties close to virgin sheet for non critical parts.

Design notes

• use corner radii of at least three times the sheet thickness to avoid thinning
• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• avoid sharp steps in the mould, which show as chill marks on the finished surface

Finishing and assembly options

• satin finish
• as formed gloss
• soft touch coating
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample.

• ISO 9001 quality system
• PPAP or ISIR on request
• food contact declarations available

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 10–15 working days, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Request a quotation

Send the drawing or a photo of the current equipment covers with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.