Sign Faces 10 mm polypropylene Supplier for Ev Charging Equipment

These polypropylene sign faces are thick gauge vacuum formed parts supplied to drawing for EV charging. They are formed from polypropylene sheet at 10 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• polypropylene keeps the weight down while stiffness is held through the formed shape
• Powder coat finish finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• material certificates with every batch

Typical applications

• cable management panels
• wallbox covers
• payment terminal bezels
• charger housings
• sign faces used across general EV charging builds

How it is made

1. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
2. The part cools on a jig so the shape is held while the material stabilises.
3. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
4. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
5. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.

Material: polypropylene

Polypropylene survives repeated impact and most cleaning chemicals. Its low forming temperature keeps cycles short, but it shrinks more, so the mould is cut with the shrink factor built in.

Design notes

• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• avoid sharp steps in the mould, which show as chill marks on the finished surface
• use corner radii of at least three times the sheet thickness to avoid thinning
• call out the finish on the drawing: mould texture, paint, or as-formed gloss

Finishing and assembly options

• powder coat finish
• clear protective film
• soft touch coating
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample. Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch.

• PPAP or ISIR on request
• food contact declarations available
• UL94 V-0 grades available

Packing and delivery

Each part is bagged, edges protected with foam, then cartonised for container loading. Standard lead time to first article is 3–4 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Request a quotation

Send the drawing or a photo of the current sign faces with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.