Skid Plates HIPS in 2 mm for Elevator And Escalator Interiors – Formed to Drawing

These HIPS skid plates are thick gauge vacuum formed parts supplied to drawing for elevator and escalator interiors. They are formed from HIPS sheet at 2 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• HIPS keeps the weight down while stiffness is held through the formed shape
• Pad printed logos finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• dimension reports with every release

Typical applications

• car linings
• handrail deck covers
• landing sill covers
• ceiling panels
• skid plates used across general elevator and escalator interiors builds

How it is made

1. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
2. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
3. The part cools on a jig so the shape is held while the material stabilises.
4. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
5. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.

Material: HIPS

HIPS is the low cost route for indoor liners and disposable trays where impact strength is not critical.

Design notes

• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• avoid sharp steps in the mould, which show as chill marks on the finished surface
• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• use corner radii of at least three times the sheet thickness to avoid thinning

Finishing and assembly options

• pad printed logos
• two coat polyurethane paint
• hot stamped accents
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch. Batch releases carry a dimensional report, material certificate and, where agreed, PPAP or ISIR documentation.

• ISO 9001 quality system
• material certificates with every batch
• RoHS compliant grades available

Packing and delivery

Parts are stacked with interleaved film and packed in export cartons on pallets. Standard lead time to first article is 2–3 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Request a quotation

Send the drawing or a photo of the current skid plates with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.