Tank Covers 12 mm ABS/PC Supplier for Playground Equipment Equipment

These ABS/PC tank covers are thick gauge vacuum formed parts supplied to drawing for playground equipment. They are formed from ABS/PC sheet at 12 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• ABS/PC keeps the weight down while stiffness is held through the formed shape
• Mould texture finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• RoHS compliant grades available

Typical applications

• seat buckets
• climbing tower caps
• panel covers
• slide shells
• tank covers used across general playground equipment builds

How it is made

1. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
2. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
3. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
4. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
5. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.

Material: ABS/PC

ABS/PC carries higher heat resistance than ABS alone, which matters for housings around motors, drives and power electronics.

Design notes

• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• use corner radii of at least three times the sheet thickness to avoid thinning

Finishing and assembly options

• mould texture
• as formed gloss
• two coat polyurethane paint
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch. Batch releases carry a dimensional report, material certificate and, where agreed, PPAP or ISIR documentation.

• dimension reports with every release
• PPAP or ISIR on request
• REACH compliant sheet available

Packing and delivery

Each part is bagged, edges protected with foam, then cartonised for container loading. Standard lead time to first article is 2–3 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Request a quotation

Send the drawing or a photo of the current tank covers with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.