Thick Gauge recycled HDPE Hoppers in 12 mm – Cleaning And Sanitation Equipment Range

These recycled HDPE hoppers are thick gauge vacuum formed parts supplied to drawing for cleaning and sanitation equipment. They are formed from recycled HDPE sheet at 12 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• recycled HDPE keeps the weight down while stiffness is held through the formed shape
• Emi shielding coating finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• UL94 V-0 grades available

Typical applications

• tool trays
• machine covers
• solution tank liners
• scrubber tanks
• hoppers used across general cleaning and sanitation equipment builds

How it is made

1. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
2. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
3. The part cools on a jig so the shape is held while the material stabilises.
4. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
5. Sheet is dried when the material needs it, then heated to forming temperature on the machine.

Material: recycled HDPE

Recycled HDPE sheet lowers material cost and supports sustainability targets, with mechanical properties close to virgin sheet for non critical parts.

Design notes

• use corner radii of at least three times the sheet thickness to avoid thinning
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• avoid sharp steps in the mould, which show as chill marks on the finished surface

Finishing and assembly options

• EMI shielding coating
• clear protective film
• hot stamped accents
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch. Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report.

• dimension reports with every release
• ISO 9001 quality system
• REACH compliant sheet available

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 2–3 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Request a quotation

Send the drawing or a photo of the current hoppers with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.