HIPS Protective Guards Vacuum Formed in 2 mm for Aerospace Interiors

These HIPS protective guards are thick gauge vacuum formed parts supplied to drawing for aerospace interiors. They are formed from HIPS sheet at 2 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• HIPS keeps the weight down while stiffness is held through the formed shape
• Uv stabilised as formed finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• food contact declarations available

Typical applications

• galley liners
• seat back shells
• stowage bin trays
• lavatory panels
• protective guards used across general aerospace interiors builds

How it is made

1. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
2. The part cools on a jig so the shape is held while the material stabilises.
3. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
4. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
5. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.

Material: HIPS

HIPS is the low cost route for indoor liners and disposable trays where impact strength is not critical.

Design notes

• use corner radii of at least three times the sheet thickness to avoid thinning
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• avoid sharp steps in the mould, which show as chill marks on the finished surface

Finishing and assembly options

• UV stabilised as formed
• pad printed logos
• clear protective film
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample.

• REACH compliant sheet available
• UL94 V-0 grades available
• RoHS compliant grades available

Packing and delivery

Each part is bagged, edges protected with foam, then cartonised for container loading. Standard lead time to first article is 2–3 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Request a quotation

Send the drawing or a photo of the current protective guards with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.