Control Panels 2 mm PETG Supplier for Elevator And Escalator Interiors Equipment

These PETG control panels are thick gauge vacuum formed parts supplied to drawing for elevator and escalator interiors. They are formed from PETG sheet at 2 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• PETG keeps the weight down while stiffness is held through the formed shape
• Anti static coating finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• dimension reports with every release

Typical applications

• car linings
• landing sill covers
• handrail deck covers
• ceiling panels
• control panels used across general elevator and escalator interiors builds

How it is made

1. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
2. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
3. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
4. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
5. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.

Material: PETG

PETG forms at a low temperature, holds detail well and is accepted for food contact, which suits trays, guards and machine covers in food plants.

Design notes

• plan the trim line on a flat face so the router can hold tolerance
• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• use corner radii of at least three times the sheet thickness to avoid thinning
• avoid sharp steps in the mould, which show as chill marks on the finished surface

Finishing and assembly options

• anti static coating
• anti graffiti coating
• pad printed logos
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample.

• ISO 9001 quality system
• UL94 V-0 grades available
• dimension reports with every release

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 2–3 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Request a quotation

Send the drawing or a photo of the current control panels with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.