HIPS Splash Guards Vacuum Formed in 6 mm for Garden And Outdoor Power Equipment

These HIPS splash guards are thick gauge vacuum formed parts supplied to drawing for garden and outdoor power equipment. They are formed from HIPS sheet at 6 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• HIPS keeps the weight down while stiffness is held through the formed shape
• Hot stamped accents finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• ISO 9001 quality system

Typical applications

• mower decks
• grass catcher shells
• tool trays
• engine covers
• splash guards used across general garden and outdoor power equipment builds

How it is made

1. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
2. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
3. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
4. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
5. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.

Material: HIPS

HIPS is the low cost route for indoor liners and disposable trays where impact strength is not critical.

Design notes

• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• avoid sharp steps in the mould, which show as chill marks on the finished surface

Finishing and assembly options

• hot stamped accents
• soft touch coating
• pad printed logos
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample.

• UL94 V-0 grades available
• dimension reports with every release
• material certificates with every batch

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 2–3 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Request a quotation

Send the drawing or a photo of the current splash guards with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.