3 mm polypropylene Skid Plates Manufacturer for Telecom And Network Cabinets

These polypropylene skid plates are thick gauge vacuum formed parts supplied to drawing for telecom and network cabinets. They are formed from polypropylene sheet at 3 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• polypropylene keeps the weight down while stiffness is held through the formed shape
• Powder coat finish finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• dimension reports with every release

Typical applications

• cabinet tops
• equipment shelves
• antenna radomes
• cable trays
• skid plates used across general telecom and network cabinets builds

How it is made

1. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
2. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
3. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
4. The part cools on a jig so the shape is held while the material stabilises.
5. Sheet is dried when the material needs it, then heated to forming temperature on the machine.

Material: polypropylene

Polypropylene survives repeated impact and most cleaning chemicals. Its low forming temperature keeps cycles short, but it shrinks more, so the mould is cut with the shrink factor built in.

Design notes

• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• plan the trim line on a flat face so the router can hold tolerance
• avoid sharp steps in the mould, which show as chill marks on the finished surface

Finishing and assembly options

• powder coat finish
• soft touch coating
• satin finish
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Batch releases carry a dimensional report, material certificate and, where agreed, PPAP or ISIR documentation. Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report.

• food contact declarations available
• material certificates with every batch
• REACH compliant sheet available

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 3–4 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Request a quotation

Send the drawing or a photo of the current skid plates with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.