Tank Liners polypropylene in 4 mm for Beauty And Spa Equipment – Formed to Drawing

These polypropylene tank liners are thick gauge vacuum formed parts supplied to drawing for beauty and spa equipment. They are formed from polypropylene sheet at 4 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• polypropylene keeps the weight down while stiffness is held through the formed shape
• Anti graffiti coating finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• food contact declarations available

Typical applications

• device housings
• lamp covers
• treatment bed shells
• trolley trays
• tank liners used across general beauty and spa equipment builds

How it is made

1. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
2. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
3. The part cools on a jig so the shape is held while the material stabilises.
4. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
5. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.

Material: polypropylene

Polypropylene survives repeated impact and most cleaning chemicals. Its low forming temperature keeps cycles short, but it shrinks more, so the mould is cut with the shrink factor built in.

Design notes

• plan the trim line on a flat face so the router can hold tolerance
• avoid sharp steps in the mould, which show as chill marks on the finished surface
• use corner radii of at least three times the sheet thickness to avoid thinning
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly

Finishing and assembly options

• anti graffiti coating
• pad printed logos
• as formed gloss
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch. Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report.

• UL94 V-0 grades available
• material certificates with every batch
• food contact declarations available

Packing and delivery

Each part is bagged, edges protected with foam, then cartonised for container loading. Standard lead time to first article is 3–4 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Request a quotation

Send the drawing or a photo of the current tank liners with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.