Component Trays 6 mm PVC Supplier for Battery Energy Storage Equipment

These PVC component trays are thick gauge vacuum formed parts supplied to drawing for battery energy storage. They are formed from PVC sheet at 6 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• PVC keeps the weight down while stiffness is held through the formed shape
• Soft touch coating finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• food contact declarations available

Typical applications

• vent shrouds
• cabinet liners
• battery pack covers
• cell trays
• component trays used across general battery energy storage builds

How it is made

1. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
2. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
3. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
4. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
5. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.

Material: PVC

PVC sheet brings flame retardancy and chemical resistance at a low price, common in equipment covers and clean room panels.

Design notes

• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• avoid sharp steps in the mould, which show as chill marks on the finished surface
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• hold the draw ratio near 1:1 for deep parts, or specify plug assist

Finishing and assembly options

• soft touch coating
• UV stabilised as formed
• satin finish
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample. Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report.

• dimension reports with every release
• PPAP or ISIR on request
• food contact declarations available

Packing and delivery

Each part is bagged, edges protected with foam, then cartonised for container loading. Standard lead time to first article is 10–15 working days, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Request a quotation

Send the drawing or a photo of the current component trays with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.