polycarbonate Carry Cases Vacuum Formed in 2 mm for Elevator And Escalator Interiors

These polycarbonate carry cases are thick gauge vacuum formed parts supplied to drawing for elevator and escalator interiors. They are formed from polycarbonate sheet at 2 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• polycarbonate keeps the weight down while stiffness is held through the formed shape
• Anti static coating finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• dimension reports with every release

Typical applications

• ceiling panels
• landing sill covers
• handrail deck covers
• car linings
• carry cases used across general elevator and escalator interiors builds

How it is made

1. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
2. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
3. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
4. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
5. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.

Material: polycarbonate

Polycarbonate is used when the housing must survive impact or carry a glazing function. It must be dried before forming or the sheet will bubble.

Design notes

• plan the trim line on a flat face so the router can hold tolerance
• avoid sharp steps in the mould, which show as chill marks on the finished surface
• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• use corner radii of at least three times the sheet thickness to avoid thinning

Finishing and assembly options

• anti static coating
• pad printed logos
• satin finish
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample.

• UL94 V-0 grades available
• RoHS compliant grades available
• PPAP or ISIR on request

Packing and delivery

Parts are nested to save freight, with returnable dunnage available on repeat routes. Standard lead time to first article is 10–15 working days, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Request a quotation

Send the drawing or a photo of the current carry cases with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.