Cable Covers 12 mm recycled HDPE Supplier for Semiconductor Equipment Equipment

These recycled HDPE cable covers are thick gauge vacuum formed parts supplied to drawing for semiconductor equipment. They are formed from recycled HDPE sheet at 12 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• recycled HDPE keeps the weight down while stiffness is held through the formed shape
• Silk screened markings finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• dimension reports with every release

Typical applications

• fan shrouds
• chemical tank liners
• carrier trays
• equipment covers
• cable covers used across general semiconductor equipment builds

How it is made

1. The part cools on a jig so the shape is held while the material stabilises.
2. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
3. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
4. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
5. Sheet is dried when the material needs it, then heated to forming temperature on the machine.

Material: recycled HDPE

Recycled HDPE sheet lowers material cost and supports sustainability targets, with mechanical properties close to virgin sheet for non critical parts.

Design notes

• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• plan the trim line on a flat face so the router can hold tolerance

Finishing and assembly options

• silk screened markings
• soft touch coating
• as formed gloss
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Batch releases carry a dimensional report, material certificate and, where agreed, PPAP or ISIR documentation. Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report.

• REACH compliant sheet available
• material certificates with every batch
• PPAP or ISIR on request

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 2–3 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Request a quotation

Send the drawing or a photo of the current cable covers with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.