Fenders 8 mm ABS/PC Supplier for Office Furniture Equipment

These ABS/PC fenders are thick gauge vacuum formed parts supplied to drawing for office furniture. They are formed from ABS/PC sheet at 8 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• ABS/PC keeps the weight down while stiffness is held through the formed shape
• Silk screened markings finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• PPAP or ISIR on request

Typical applications

• desk modesty panels
• chair shells
• cable trays
• screen frames
• fenders used across general office furniture builds

How it is made

1. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
2. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
3. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
4. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
5. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.

Material: ABS/PC

ABS/PC carries higher heat resistance than ABS alone, which matters for housings around motors, drives and power electronics.

Design notes

• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• use corner radii of at least three times the sheet thickness to avoid thinning

Finishing and assembly options

• silk screened markings
• hot stamped accents
• two coat polyurethane paint
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch. Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report.

• RoHS compliant grades available
• ISO 9001 quality system
• food contact declarations available

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 10–15 working days, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Request a quotation

Send the drawing or a photo of the current fenders with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.