Light Housings 5 mm recycled HDPE Supplier for Atv And Utv Equipment

These recycled HDPE light housings are thick gauge vacuum formed parts supplied to drawing for ATV and UTV. They are formed from recycled HDPE sheet at 5 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• recycled HDPE keeps the weight down while stiffness is held through the formed shape
• Soft touch coating finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• material certificates with every batch

Typical applications

• dash panels
• cargo box liners
• hoods
• fenders
• light housings used across general ATV and UTV builds

How it is made

1. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
2. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
3. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
4. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
5. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.

Material: recycled HDPE

Recycled HDPE sheet lowers material cost and supports sustainability targets, with mechanical properties close to virgin sheet for non critical parts.

Design notes

• avoid sharp steps in the mould, which show as chill marks on the finished surface
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• call out the finish on the drawing: mould texture, paint, or as-formed gloss

Finishing and assembly options

• soft touch coating
• as formed gloss
• anti static coating
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch. Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report.

• food contact declarations available
• dimension reports with every release
• PPAP or ISIR on request

Packing and delivery

Each part is bagged, edges protected with foam, then cartonised for container loading. Standard lead time to first article is 7–15 working days, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Request a quotation

Send the drawing or a photo of the current light housings with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.