3 mm polycarbonate Splash Guards Manufacturer for Playground Equipment

These polycarbonate splash guards are thick gauge vacuum formed parts supplied to drawing for playground equipment. They are formed from polycarbonate sheet at 3 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• polycarbonate keeps the weight down while stiffness is held through the formed shape
• Pad printed logos finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• REACH compliant sheet available

Typical applications

• slide shells
• seat buckets
• panel covers
• climbing tower caps
• splash guards used across general playground equipment builds

How it is made

1. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
2. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
3. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
4. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
5. Sheet is dried when the material needs it, then heated to forming temperature on the machine.

Material: polycarbonate

Polycarbonate is used when the housing must survive impact or carry a glazing function. It must be dried before forming or the sheet will bubble.

Design notes

• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• plan the trim line on a flat face so the router can hold tolerance
• avoid sharp steps in the mould, which show as chill marks on the finished surface

Finishing and assembly options

• pad printed logos
• mould texture
• soft touch coating
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch. First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample.

• material certificates with every batch
• dimension reports with every release
• PPAP or ISIR on request

Packing and delivery

Parts are nested to save freight, with returnable dunnage available on repeat routes. Standard lead time to first article is 2–3 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Request a quotation

Send the drawing or a photo of the current splash guards with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.