Thick Gauge HDPE Equipment Covers in 6 mm – Medical Equipment Range

These HDPE equipment covers are thick gauge vacuum formed parts supplied to drawing for medical equipment. They are formed from HDPE sheet at 6 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• HDPE keeps the weight down while stiffness is held through the formed shape
• Hot stamped accents finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• RoHS compliant grades available

Typical applications

• imaging equipment panels
• monitor shrouds
• device trolleys
• dialysis machine covers
• equipment covers used across general medical equipment builds

How it is made

1. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
2. The part cools on a jig so the shape is held while the material stabilises.
3. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
4. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
5. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.

Material: HDPE

HDPE is chosen for chemical resistance and impact strength at low temperature. It needs more heat and a longer cooling cycle than ABS, and it is painted only after flame or plasma treatment.

Design notes

• use corner radii of at least three times the sheet thickness to avoid thinning
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• avoid sharp steps in the mould, which show as chill marks on the finished surface

Finishing and assembly options

• hot stamped accents
• silk screened markings
• two coat polyurethane paint
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch.

• ISO 9001 quality system
• dimension reports with every release
• UL94 V-0 grades available

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 3–4 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Request a quotation

Send the drawing or a photo of the current equipment covers with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.