OEM Display Shells ABS/PMMA in 10 mm for Elevator And Escalator Interiors

These ABS/PMMA display shells are thick gauge vacuum formed parts supplied to drawing for elevator and escalator interiors. They are formed from ABS/PMMA sheet at 10 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• ABS/PMMA keeps the weight down while stiffness is held through the formed shape
• Two coat polyurethane paint finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• food contact declarations available

Typical applications

• handrail deck covers
• ceiling panels
• car linings
• landing sill covers
• display shells used across general elevator and escalator interiors builds

How it is made

1. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
2. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
3. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
4. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
5. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.

Material: ABS/PMMA

ABS/PMMA combines an ABS core with a hard acrylic cap, so the part has the toughness of ABS and the UV and scratch resistance of acrylic.

Design notes

• use corner radii of at least three times the sheet thickness to avoid thinning
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• hold the draw ratio near 1:1 for deep parts, or specify plug assist

Finishing and assembly options

• two coat polyurethane paint
• hot stamped accents
• UV stabilised as formed
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch.

• RoHS compliant grades available
• dimension reports with every release
• PPAP or ISIR on request

Packing and delivery

Each part is bagged, edges protected with foam, then cartonised for container loading. Standard lead time to first article is 7–15 working days, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Request a quotation

Send the drawing or a photo of the current display shells with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.