Thick Gauge polycarbonate Centre Consoles in 8 mm – Fitness Equipment Range

These polycarbonate centre consoles are thick gauge vacuum formed parts supplied to drawing for fitness equipment. They are formed from polycarbonate sheet at 8 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• polycarbonate keeps the weight down while stiffness is held through the formed shape
• Uv stabilised as formed finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• REACH compliant sheet available

Typical applications

• treadmill motor covers
• console housings
• weight stack shrouds
• seat shells
• centre consoles used across general fitness equipment builds

How it is made

1. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
2. The part cools on a jig so the shape is held while the material stabilises.
3. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
4. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
5. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.

Material: polycarbonate

Polycarbonate is used when the housing must survive impact or carry a glazing function. It must be dried before forming or the sheet will bubble.

Design notes

• avoid sharp steps in the mould, which show as chill marks on the finished surface
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly

Finishing and assembly options

• UV stabilised as formed
• pad printed logos
• satin finish
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch.

• ISO 9001 quality system
• PPAP or ISIR on request
• dimension reports with every release

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 3–4 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Request a quotation

Send the drawing or a photo of the current centre consoles with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.