ABS/PC Instrument Bezels Vacuum Formed in 3 mm for Laboratory Instruments

These ABS/PC instrument bezels are thick gauge vacuum formed parts supplied to drawing for laboratory instruments. They are formed from ABS/PC sheet at 3 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• ABS/PC keeps the weight down while stiffness is held through the formed shape
• Clear protective film finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• PPAP or ISIR on request

Typical applications

• instrument covers
• sample tray systems
• analyser housings
• fume hood liners
• instrument bezels used across general laboratory instruments builds

How it is made

1. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
2. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
3. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
4. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
5. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.

Material: ABS/PC

ABS/PC carries higher heat resistance than ABS alone, which matters for housings around motors, drives and power electronics.

Design notes

• avoid sharp steps in the mould, which show as chill marks on the finished surface
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly
• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time

Finishing and assembly options

• clear protective film
• satin finish
• as formed gloss
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Moulds, trim fixtures and programmes are stored against the part number, so a repeat order matches the first batch. Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report.

• PPAP or ISIR on request
• material certificates with every batch
• REACH compliant sheet available

Packing and delivery

Each part is bagged, edges protected with foam, then cartonised for container loading. Standard lead time to first article is 3–4 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Request a quotation

Send the drawing or a photo of the current instrument bezels with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.