polypropylene Light Housings Vacuum Formed in 10 mm for Beauty And Spa Equipment

These polypropylene light housings are thick gauge vacuum formed parts supplied to drawing for beauty and spa equipment. They are formed from polypropylene sheet at 10 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• polypropylene keeps the weight down while stiffness is held through the formed shape
• Uv stabilised as formed finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• material certificates with every batch

Typical applications

• device housings
• treatment bed shells
• trolley trays
• lamp covers
• light housings used across general beauty and spa equipment builds

How it is made

1. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
2. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
3. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
4. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
5. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.

Material: polypropylene

Polypropylene survives repeated impact and most cleaning chemicals. Its low forming temperature keeps cycles short, but it shrinks more, so the mould is cut with the shrink factor built in.

Design notes

• add ribs or returns instead of increasing sheet thickness to save weight and cycle time
• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• use corner radii of at least three times the sheet thickness to avoid thinning
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly

Finishing and assembly options

• UV stabilised as formed
• anti graffiti coating
• satin finish
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. First article inspection covers critical dimensions, wall thickness, colour and texture against the approved sample.

• ISO 9001 quality system
• food contact declarations available
• dimension reports with every release

Packing and delivery

Parts are stacked with interleaved film and packed in export cartons on pallets. Standard lead time to first article is 2–3 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

How fast is the first article?

Seven to fifteen working days from drawing release for sample tooling, with production tooling in three to four weeks.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Request a quotation

Send the drawing or a photo of the current light housings with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.