Machine Housings 6 mm polycarbonate Supplier for Medical Equipment Equipment

These polycarbonate machine housings are thick gauge vacuum formed parts supplied to drawing for medical equipment. They are formed from polycarbonate sheet at 6 mm, trimmed on 5-axis routers and inspected against the drawing before packing. Buyers choose this route where a metal fabrication is too heavy, or where injection moulding tooling cannot be justified for the volume.

Product specification

Key features

• One piece shell replaces a fabrication, so assembly hours drop
• polycarbonate keeps the weight down while stiffness is held through the formed shape
• Emi shielding coating finish as standard, further finishes on request
• Trimmed on 5-axis routers, so mounting holes and cut outs match the drawing
• Tooling stored against the part number for repeat and spare orders
• dimension reports with every release

Typical applications

• dialysis machine covers
• device trolleys
• monitor shrouds
• imaging equipment panels
• machine housings used across general medical equipment builds

How it is made

1. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.
2. Drawings are reviewed and a manufacturability report is issued with wall thickness, draft and radii marked up.
3. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
4. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
5. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.

Material: polycarbonate

Polycarbonate is used when the housing must survive impact or carry a glazing function. It must be dried before forming or the sheet will bubble.

Design notes

• use corner radii of at least three times the sheet thickness to avoid thinning
• call out the finish on the drawing: mould texture, paint, or as-formed gloss
• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• keep a draft angle of at least 3 degrees on vertical walls so the part releases cleanly

Finishing and assembly options

• EMI shielding coating
• clear protective film
• two coat polyurethane paint
• Threaded inserts, PEM fasteners and brackets fitted before dispatch
• Mating parts can be trial assembled before the first article ships

Quality

Sheet thickness is checked on the formed part at the points shown on the drawing, and the readings go into the report. Batch releases carry a dimensional report, material certificate and, where agreed, PPAP or ISIR documentation.

• RoHS compliant grades available
• food contact declarations available
• REACH compliant sheet available

Packing and delivery

Large panels are crated in made to measure wooden cases with corner protection. Standard lead time to first article is 3–4 weeks, and repeat releases ship against stored tooling without a new proving run.

Frequently asked questions

Can you make it in another material?

Any grade in this family can be swapped in. Send the requirement and the material will be quoted with the price difference shown.

Are spare parts available later?

Tooling is stored against the part number for the life of the programme, so replacements or spare panels can be released at any time.

What quantity can I order?

Sample quantities start at one piece off printed tooling. The process pays back from about 25 pieces a year and runs well into several thousand.

Request a quotation

Send the drawing or a photo of the current machine housings with the quantity and the finish required. The reply covers material choice, wall thickness, tooling route and price, so the decision is made on a complete picture.