Emi shielding coatings Explained for Thick Gauge Buyers – Large Housings

In vacuum forming and thermoforming, EMI shielding coatings is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry explains what it means, the ranges that are realistic on production tooling, and what to ask for when the part is quoted.

What it affects

The main effects are on wall thickness, cycle time and how much hand work the part needs after forming. On a thick gauge part these three decide the piece price, so the decision taken here shows up in every release afterwards.

Typical values

How it is controlled

1. Trimming is done on 5-axis routers or with a dedicated trim fixture to meet the drawing.
2. Sheet is dried when the material needs it, then heated to forming temperature on the machine.
3. The sheet is formed over the mould with vacuum and, where the draw is deep, with plug assist.
4. Tooling is cut: aluminium for production volumes, composite or printed moulds for samples and first articles.
5. Parts are inspected, fitted with inserts or hardware if required, packed and shipped.

Common mistakes

• use corner radii of at least three times the sheet thickness to avoid thinning
• hold the draw ratio near 1:1 for deep parts, or specify plug assist
• avoid sharp steps in the mould, which show as chill marks on the finished surface
• add ribs or returns instead of increasing sheet thickness to save weight and cycle time

How to specify it on the drawing

Put the decision on the drawing rather than in an email: state the material and grade, the gauge, the finish, the surfaces that must not carry marks, and the tolerance that applies to the trimmed edges. Where the part has to mate with another component, mark the datum faces so the trim fixture and the inspection report use the same reference. A drawing that states these points removes most of the questions that otherwise surface during sampling.

Checklist before tooling is cut

• Material and grade fixed, including flame retardancy, UV or food contact requirements
• Gauge selected from the load case, not from habit
• Draft angle and corner radii checked against the sheet thickness
• Trim line placed on a face the router can reach
• Finish and colour standard agreed, with a reference if the colour is critical
• Inspection points agreed and noted for the dimensional report

Related terms

• Nesting for trimming
• Threaded inserts
• Batch to batch consistency
• Snap fit design
• Mould venting
• Dimensional report

Frequently asked questions

Does this change the tooling cost?

Yes. Decisions taken at drawing stage move the tooling cost more than any later change, which is why the manufacturability review is done before the tool is cut.

What information do you need to advise on it?

A 3D file, the material if it is fixed, the annual quantity and the finish. With those the answer comes back with a recommended route and a quotation.