This guide covers how to measure wall thickness on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin
This guide covers how to design surface finish on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
This guide covers how to reduce fixture design on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
This guide covers how to calculate cycle time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
This guide covers how to trim shrinkage allowance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tool
This guide covers how to plan batch repeatability on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tool
ABS and HDPE are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The comparison below is the
This guide covers how to validate scrap rate on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i
painted finish and textured sheet are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The co
This guide covers how to quote sheet heating on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i
In vacuum forming and thermoforming, post forming shrinkage is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry expla
This guide covers how to design scrap rate on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
