This guide covers how to specify draw ratio on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
This guide covers how to troubleshoot texture depth on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before to
This guide covers how to compare draw ratio on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
This guide covers how to compare trim tolerance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin
This guide covers how to quote corner strength on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
This guide covers how to reduce part nesting on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i
This guide covers how to specify draft angle on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i
This guide covers how to measure shrinkage allowance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before t
This guide covers how to control scrap rate on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
ABS and HDPE are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The comparison below is the
This guide covers how to calculate tooling cost on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin
In vacuum forming and thermoforming, formed-in ribs is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry explains what
