This guide covers how to quote shrinkage allowance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before too
This guide covers how to specify trim tolerance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin
vacuum forming and sheet metal fabrication are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished par
This guide covers how to choose shrinkage allowance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before to
This guide covers how to improve lead time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
This guide covers how to plan mould venting on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
This guide covers how to compare draft angle on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i
ABS and HDPE are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The comparison below is the
ABS and polycarbonate are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The comparison bel
bubbles in the sheet is one of the faults that shows up during sampling on any new thick gauge tool. It is visible on the part, but the cause is usually in the mould, the heating cycle or th
This guide covers how to design sheet material on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
This guide covers how to improve lead time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
