This guide covers how to reduce shrinkage allowance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before to
This guide covers how to improve gloss level on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i
This guide covers how to design rib layout on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
This guide covers how to calculate surface finish on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tool
This guide covers how to improve surface finish on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin
In vacuum forming and thermoforming, flame retardant grades is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry expla
ABS and HDPE are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The comparison below is the
In vacuum forming and thermoforming, EMI shielding coatings is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry expla
In vacuum forming and thermoforming, sheet sag is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry explains what it m
This guide covers how to plan shrinkage allowance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tool
In vacuum forming and thermoforming, undercuts in thermoforming is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry e
This guide covers how to measure lead time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
