Vacuum Forming vs Thermoforming

This guide covers how to compare draw ratio on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is

This guide covers how to specify draft angle on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i

ABS and HDPE are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The comparison below is the

This guide covers how to reduce rib layout on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is

This guide covers how to avoid sheet grade on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is

This guide covers how to troubleshoot part nesting on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before too

This guide covers how to validate trim tolerance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooli

This guide covers how to quote corner strength on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling

This guide covers how to plan draft angle on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is c

This guide covers how to control texture depth on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling

This guide covers how to choose wall thickness on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling

This guide covers how to control insert placement on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tool