EV Charger Plastic Enclosures

webbing in recesses is one of the faults that shows up during sampling on any new thick gauge tool. It is visible on the part, but the cause is usually in the mould, the heating cycle or the

This guide covers how to plan cool down time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i

In vacuum forming and thermoforming, tolerance stack up is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry explains

This guide covers how to design cycle time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is

This guide covers how to troubleshoot part nesting on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before too

This guide covers how to measure scrap rate on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is

This guide covers how to measure rib layout on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is

flame retardant ABS and standard ABS are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The

This guide covers how to plan trim tolerance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i

formed-in ribs and increased sheet thickness are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished p

This guide covers how to trim draw ratio on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is cu

In vacuum forming and thermoforming, CNC trimming is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry explains what i