Thermoforming Factory Tour

This guide covers how to compare lead time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is

In vacuum forming and thermoforming, bridging is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry explains what it me

This guide covers how to specify batch repeatability on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before t

This guide covers how to measure draw ratio on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is

UV stabilised HDPE and standard HDPE are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The

This guide covers how to trim draft angle on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is c

This guide covers how to control scrap rate on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is

This guide covers how to choose cycle time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is

This guide covers how to validate colour consistency on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before t

This guide covers how to control trim tolerance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin

This guide covers how to calculate trim tolerance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tool

In vacuum forming and thermoforming, vacuum leak detection is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry explai