Quality Control Process

HIPS and ABS are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The comparison below is the

This guide covers how to quote fixture design on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling

This guide covers how to reduce scrap rate on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is

This guide covers how to troubleshoot scrap rate on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooli

This guide covers how to avoid fixture design on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling

This guide covers how to design rib layout on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is

3D printed tooling and aluminium tooling are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part.

This guide covers how to avoid scrap rate on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is c

This guide covers how to compare surface finish on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin

This guide covers how to avoid sheet heating on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i

This guide covers how to control surface finish on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin

This guide covers how to calculate draft angle on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling