TPO and ABS are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The comparison below is the
This guide covers how to troubleshoot draw ratio on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooli
This guide covers how to validate lead time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
This guide covers how to compare draft angle on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i
This guide covers how to validate mould venting on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin
This guide covers how to specify trim tolerance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin
In vacuum forming and thermoforming, shrinkage allowance is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry explains
This guide covers how to control first article approval on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems befor
This guide covers how to design scrap rate on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
single cavity tooling and multi cavity tooling are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished
This guide covers how to troubleshoot scrap rate on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooli
This guide covers how to plan texture depth on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
