This guide covers how to specify cool down time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin
This guide covers how to compare draw ratio on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
This guide covers how to calculate draft angle on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
In vacuum forming and thermoforming, uneven heating is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry explains what
This guide covers how to troubleshoot lead time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin
This guide covers how to specify cycle time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
PMMA acrylic and polycarbonate are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The compa
painted finish and textured sheet are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The co
This guide covers how to maintain trim tolerance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooli
This guide covers how to compare scrap rate on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
This guide covers how to choose sheet material on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
This guide covers how to improve rib layout on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
