This guide covers how to validate draft angle on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
This guide covers how to improve rib layout on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
This guide covers how to design wall thickness on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
chill marks on side walls is one of the faults that shows up during sampling on any new thick gauge tool. It is visible on the part, but the cause is usually in the mould, the heating cycle
PVC and ABS are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The comparison below is the
This guide covers how to plan wall thickness on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i
This guide covers how to maintain tooling cost on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
This guide covers how to troubleshoot part nesting on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before too
HDPE and polypropylene are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The comparison be
This guide covers how to control draw ratio on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
This guide covers how to improve shrinkage allowance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before t
This guide covers how to troubleshoot cool down time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before t
