This guide covers how to design insert placement on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooli
This guide covers how to calculate cycle time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
This guide covers how to design wall thickness on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
This guide covers how to plan wall thickness on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i
thick gauge forming and thin gauge forming are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished par
chill marks on side walls is one of the faults that shows up during sampling on any new thick gauge tool. It is visible on the part, but the cause is usually in the mould, the heating cycle
This guide covers how to reduce part nesting on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i
This guide covers how to specify lead time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is
painted finish and textured sheet are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The co
This guide covers how to improve part nesting on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
HDPE and polypropylene are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The comparison be
This guide covers how to trim insert placement on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
