This guide covers how to specify trim tolerance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before toolin
This guide covers how to maintain tooling cost on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
This guide covers how to plan shrinkage allowance on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tool
This guide covers how to improve draft angle on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling i
This guide covers how to validate corner strength on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tool
In vacuum forming and thermoforming, bridging is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry explains what it me
This guide covers how to design lead time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling is c
In vacuum forming and thermoforming, regrind content is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry explains wha
This guide covers how to specify mould venting on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooling
In vacuum forming and thermoforming, ultrasonic welding is one of the variables that decides whether a part comes off the machine within tolerance or has to be reworked. This entry explains
This guide covers how to maintain cool down time on a vacuum formed part: what the designer has to decide, what the mould maker needs to know, and the checks that catch problems before tooli
ABS and HDPE are both used on the same kind of plastic parts, and the choice between them changes tooling cost, lead time and the properties of the finished part. The comparison below is the
